Bradford-White Corp IGE-199R User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 46
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
WARNING
This water heater is suitable for potable water heating only. DO NOT use
this water heater for space heating or combination space heating/domestic
water heating.
This water heater is not suitable for use in pool or spa applications.
The water heater must be installed outdoors. Failure to properly install this
water heater outdoors may result in property damage, personal injury, o
r
death. Refer to the installation of the water heater in this installation and
instruction manual for details on the location and installation outdoors. DO
NOT INSTALL INDOORS.
WARNING
WARNING
Pressure relief valve discharge piping must be piped near the ground or drain to eliminate
potential of severe burns. Insulate and use electrical heat tape around the discharge drain
pipe in any area where freezing could occur. Do not install any shut-off valves, plugs or caps
to the pressure relief valve or discharge piping.
CAUTION
If building cold water supply has a back-flow preventer, check valve or water meter with check
valve, provisions for thermal expansion of water in the hot water system must be provided.
DANGER
Temperature setting should not exceed safe temperature at fixtures. See water temperature
control warnings in the “Temperature Adjustment Section” of this Installation and Operating
Instruction Manual. If higher preheat temperatures are necessary to obtain adequate booster
output, add an ASSE approved mixing valve for hot water supplied to fixtures.
UNPACKING
INSPECT SHIPMENT carefully for any signs of damage.
1. All equipment is carefully manufactured, inspected and packed.
2. Any claims for damage or shortage in shipment must be filed immediately with Bradford White
Corporation and noted on the Bill of Lading.
WATER HEATER LOCATION:
1. The IGE series water heaters must be installed outdoors. Refer to figure 1 and table 1 (Section
IV) in this Installation and Instruction Manual for minimum installation clearances before choosing
a final location for the water heater.
2. The water heater must be installed on a wall capable of supporting at least 50 pounds (23 Kg).
Locate the water heater at a height convenient for servicing and above the reach of small
children.
3. Minimum clearance to combustible material is 12” (30.5 cm) from the Top, 24” (61 cm) from the
Front, 0” from the Rear, 6” (15.2 cm) from the Sides, and 12” (30.5 cm) from the Bottom of this
water heater. An optional recess box is available for installing the water heater recessed in an
outside wall and enclosing the piping (see features section). When the water heater is installed in
a recess box, the clearances from the top, bottom, sides, and back surfaces of the recess box to
combustible materials are 0”. The clearance from combustibles from the front of the recess box
10
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 45 46

Comments to this Manuals

No comments